TIA-210 Single Ended Integrated Amplifier ( 2011 New Product )
10Watt x 2 (Triode), 15Watt x 2 (Ultra Linear), KT66 x 4 / 6SN7 x 2 / 6SL7 x 2 ( All Matching DCT tubes )
Market Selling Price: US$3,980 / set
Coming Soon!
TECHNICAL SPECIFICATION
Power Output
Minimum sine wave continuous average power output per
channel, both channels operating is:
10 watts (Triode) 15 watts ( Ultra-Linear ) into a 4 ohm load
10 watts (Triode) 15 watts ( Ultra-Linear ) into an 8 ohm load
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power level from 250 mill watts to rated power output is:
0.5% for a 4 or 8 ohm load
Frequency Response
+0, -0.5dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 50,000Hz
Sensitivity
High Level: 450mV for 2.5V rated output
Power Amplifier Input: 2.5V for rated output
A-Weighted Signal To Noise Ratio
High Level: 99dB below rated output
Power Amplifier: 120dB below rated output
Inter Modulation Distortion
Maximum Inter modulation Distortion if instantaneous peak output does not exceed twice the rated output,
for any combination of frequencies from 20Hz to 20,000Hz is:
0.5% for a 4 or 8 ohm load
Input Impedance
High: Level, 100K ohms
Maximum Input Signal
High Level: 8V
Voltage Gain
High Level to Main: 18dB
Wide Band Damping Factor
Greater than 30
Power Requirements
100 Volts, 50/60Hz at 4.0 amps
110 Volts, 50/60Hz at 4.0 amps
120 Volts, 50/60Hz at 4.0 amps
220 Volts, 50/60Hz at 2.0 amps
230 Volts, 50/60Hz at 2.0 amps
240 Volts, 50/60Hz at 2.0 amps
Note: Refer to the rear panel of the TIA-210
for the correct voltage.
Preamplifier Tube Compliment
2 - 6SL7 High Level Circuitry
2 - 6SN7 Phase Reversal
Power Amplifier Tube Compliment
4 - KT66
Overall Dimensions
Width is 16-7/8inches (43.0cm)
Height is 8-1/4 inches (21.0cm) including feet
Depth is 16-1/2 inches (42.0cm) including the Front Panel and Knobs
Weight 56 pounds (25.5kg) net, 60 pounds (29.5kg) in shipping carton
